GM4300F Pioneer 4CH 400W AMP

Features

• Internal Crossovers: The amplifier's internal front and rear crossovers are 12dB/octave filters, independently selectable for high-pass, low-pass, or full-range operation. Each crossover is fixed at 80 Hz.
• Preamp Outputs: The preamp output jacks provide a convenient source for daisy-chaining an additional amplifier without running an extra set of RCA cables from the front of the vehicle to the amplifier location. These outputs provide a full-range signal.
• BFC (Beat Frequency Control) Switch: If you hear a beat while listening to an AM broadcast with your car stereo, change the BFC switch using a small standard tip screwdriver. The switch is located to the right of the speaker output terminals.
• Power Connections: The power and ground connections are 0.531" wide screw terminals that will accommodate up to 4-gauge wire. The remote turn-on terminal is 0.325" wide and will accept up to 8-gauge wire. A Phillips-head or flat blade screw driver (not supplied) is required to tighten/loosen the terminals. Spade connectors are recommended for the power, ground, and remote wires.
• Speaker Connections: The speaker terminals are also 0.325" wide and will accommodate up to 8-gauge wire. A Phillips-head or flat blade screw driver (not supplied) is required to tighten/loosen the terminals. Spade connectors are recommended for the speaker wires.

Specifications

• 4-channel car amplifier
• 40 watts RMS x 4 at 4 ohms (50 watts RMS x 4 at 2 ohms)
• 100 watts RMS x 2 in bridged mode (4-ohm stable in bridged mode)
• CEA-2006 compliant
• 4-channel selectable high- and low-pass filters (80 Hz, 12 dB per octave)
• MOSFET power supply
• Speaker-level inputs
• Preamp inputs and outputs
• fFse rating: 40A x 1
• 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• 11-13/16"W x 2-3/8"H x 11-13/16"D
• Warranty: 1 year