GMD7400M Pioneer 800W MONO AMP

Features

• 100 % of the power, 45 % of the size  The superior efficiency of a Class-D amplifier means higher power output and greater compactness than an analog amplifier offers.

• Class-D amplifiers overcome the inefficiencies of traditional Class-A or AB amplifiers. Pioneer’s Class-D amps transform very little power into heat so a higher percentage of the power supply (67%) is transformed into the load. This results in a very compact amp which needs less input power to produce very high output power. The Class-D amplifier’s PWM (Pulse Width Modulator) modulates the original audio input signal with a triangulated signal wave which has a much higher fixed frequency. The result is a digital signal which contains both the input signal and a band of frequency components around the modulation frequency. A LPF (Low Pass Filter) then filters out the high frequency pulses and the resulting amplified output signal is then sent to the subwoofer and/or speakers.

• Bass boost gives you more control over how your music sounds. It lets you set the optimal bass level for each speaker/sub connected to the GM-D8400M, so the tone controls from your headunit can do what they do best. And because this is selectable bass boost, you can set the level at 0dB, 6dB, or 12dB, whichever sounds best to you.

• Built into the GM-D8400M is a very smart crossover network. It works like a gateway, routing the big bass signals (adjustable from 40 to 240Hz or lower, at -12dB/octave) and filtering out higher-frequency signals to that subwoofer. This optimizes your systems efficiency and delivers the best possible sound quality.

• The GM-D8400Ms speaker level inputs allow you to connect your OEM unit (or any unit that does not have the typical RCA-type inputs) without having to buy add-on adapters. So, the install goes faster, you save money, and you have a Pioneer amp in your vehicle.

• CEA 2006 Specifications
  • Output Power (4 Ohm, <=1% THD):  250 Watts x 1
  • Output Power (2 Ohm, <=1% THD):  400 Watts x 1
  • Signal to Noise (1 Watt into 4 Ohms): 80 dB
• Peak Music Power:  800 Watts
• 1 Channel 
• Load Impedance Capability:  2 ~ 8 Ohm
• Continuous Power (4 ohm):  250W x 1
• Continuous Power (2 ohm):  400W x 1
• Frequency Response:  10Hz ~ 240Hz
• Total Harmonic Distortion:  0.03%
• Signal-to-Noise Ratio:  100dB
• RCA Inputs:  2 Channel
• Speaker Level Input:  2 Channel
• Input Level Control:  Hi-Volt (200mV ~ 6.5v)
• Built-in Crossover:  Variable LPF
• Crossover Frequency Range:  40~240Hz, -12dB/Oct.
• Bass Level Control:  50Hz, 0/6/9/12dB, with remote